[TUTORIAL] Convert Jio Fiber router to an extender

1. Reset the router to factory settings using a pin by inserting it to the reset port and hold for 7-10 secs.
2. Your SSID will now be the default one mentioned on the back of the router. Use the SSID and password to connect. You can change it later anytime.
3. Connect to the router via WiFi and go to the admin page (192.168.29.1). Credentials are admin:Jiocentrum
4. Connect the LAN port of your ISP to the 1st LAN of the Jio router (the one next to the telephone port)
5. Go to LAN settings of the Jio router and disable DHCP and assign a static IP address of the same subnet of your main router. I assigned 192.168.1.150

Your Jio router admin page now will be accessible on 192.168.1.150 from here onward.

Lan Configuration :

Also, disable IPv6. I have not tried with IPv6 enabled as I read Jio router has some problem with IPv6.

6. Go to Available VLANs Tab and add a new VLAN 2

7. Goto VLAN Membership and for VLANs 2-4 select Default VLAN association as 2 and select VLAN members 1 & 2 for all the VLANs.

Without disabling VLANs 2-4 or assigning them to a different VLAN, the internet doesn't work. If you disable other VLANs, you may not be able to connect devices via the LAN port (WiFi works though). Hence you assign a new VLAN to the other LANs. Weird, but it works.

8. Goto security and disable everything on both the tabs. You already have this enabled on your main router. You don't want to do additional packet checks and increase latency.

9. Restart router and connect via 192.168.1.150 or any other IP that you have set at step no. 5


If you get stuck somewhere or unable to connect, just reset and restart.

Credits

 

[Lolita_Magnum]

That is there to stay.

 

[knarkhede1504]

hi,

wifi frm the router, (the old jio router configured as extender, using above method) is diconnecting too frequently on the devices.. it hardly connects for a second or two and drops the wifi connection.. while wired LAN connection works fine.. how to fix the WIFI issue?

 

[kapilrtn]

same problem @knarkhede1504

 

[vishmak]

Instead of using vlans just setting up DHCP relay to main router seems easier

 

[girish.s.tare]

It works perfectly but how to fix the red light blinking?

 

[avirendra]

Hi. I'm too facing disconnection issue following this instructions. Connection hardly stays for few seconds.
I'm not able to open Web interface with 192.168.1.150 after changing ip

Any one has working example of secondary Jio ont working as extender with main jio ont?

 

---

[Rash]

Even I am wondering why does the network keeps dropping. The original instructions work like a charm but after few minutes the network drops! Any help at all?

Also, to note that we are now not allowed to disable IPv6.