gadgetcrazy
Regulars
First of all I am not even remotely related to electronics/ computers, so kindly be patient.
I am using 590 NU for the last month or so and have not been able to configure my Modem to reboot automatically before 8 in the morning.
I have a UTStarcom UT-300R2U modem with me, which was configured by the MTNL people and installed by them as well. I have connected it using the Ethernet port.
The problems faced by me are:
1. I am not able to make it autoreboot using the method described by nocaps (telnet client and task scheduler). It stops at the login step only.[I followed all the steps and copied the script from cyberwiz’ post for UT300R2U.] It says waiting for login but it fails.
2. I am not able to switch to the Bridge mode (cyberwiz method).
When I log into the modem configuration site, The message reads “The device "T-KD318-***" is an ADSL Router ideal for home networking and small business networking. The setup wizard will guide you to configure the device to connect to your ADSL connection.” From what I see in the manual it should have UT300R2U instead of what is mentioned in bold letters. Am I right?
Secondly, Cyberwiz’s post mentions that I should have options for DHCP under LAN, however there are no such options, DHCP is a separate tab on the left hand side. Because of this I am not able to use any method for automatic reboot.
I know I would have made some silly errors, but I need help. I hope cyberwiz and nocaps will help. I am attaching screenshot for explanation.
I am using 590 NU for the last month or so and have not been able to configure my Modem to reboot automatically before 8 in the morning.
I have a UTStarcom UT-300R2U modem with me, which was configured by the MTNL people and installed by them as well. I have connected it using the Ethernet port.
The problems faced by me are:
1. I am not able to make it autoreboot using the method described by nocaps (telnet client and task scheduler). It stops at the login step only.[I followed all the steps and copied the script from cyberwiz’ post for UT300R2U.] It says waiting for login but it fails.
2. I am not able to switch to the Bridge mode (cyberwiz method).
When I log into the modem configuration site, The message reads “The device "T-KD318-***" is an ADSL Router ideal for home networking and small business networking. The setup wizard will guide you to configure the device to connect to your ADSL connection.” From what I see in the manual it should have UT300R2U instead of what is mentioned in bold letters. Am I right?
Secondly, Cyberwiz’s post mentions that I should have options for DHCP under LAN, however there are no such options, DHCP is a separate tab on the left hand side. Because of this I am not able to use any method for automatic reboot.
I know I would have made some silly errors, but I need help. I hope cyberwiz and nocaps will help. I am attaching screenshot for explanation.