I am currently connected to it by making a new configuration for bridge in WAN settings on the ONT and then connecting to the AX10 with ethernet and logging in with PPPoE. IPv6 is also enabled with it set to pass-through mode. My only issue at present seems to be the inability to port forward but that aside it's been a fairly smooth experience.
I am fairly new to this and have just been looking at various forums as to how I should be setting it up and have seen some people recommending turning off WiFi and DHCP on the ONT and using Dynamic IP instead of logging in with PPPoE on the AX10.
Some seem to recommend leaving the ONT as is and just using the AX10 in AP mode.
What are the recommended settings I should be using on both my ONT and router? Are there any other settings I should be enabling/disabling?
I am fairly new to this and have just been looking at various forums as to how I should be setting it up and have seen some people recommending turning off WiFi and DHCP on the ONT and using Dynamic IP instead of logging in with PPPoE on the AX10.
Some seem to recommend leaving the ONT as is and just using the AX10 in AP mode.
What are the recommended settings I should be using on both my ONT and router? Are there any other settings I should be enabling/disabling?