IPV6 Settings in TP-Link Deco for BSNL FTTH

[gregoryhouse]

Hello.
I'm using a BSNL FTTH Connection (Kerala, Kollam Circle)
My ONU Device is a Netgear HG323R (No WiFi)
I use 3X TP-Link Deco X60s for WiFi Coverage in my home. The main deco is connected to the Gigabit Port of the ONU.
Recently I configured IPV6 in my ONU, and it's working (Confirmed from the ONU Page itself).
But none of the devices connected to the WiFi are showing an IPV6 Address.
After fiddling with the Internet Settings in the Deco App, I set the Internet Connection Type to "Bridge", after doing this a few devices occasionally show IPV6 address. But not all the devices and not at all times.
Kindly help me with the correct configuration to be done in the Deco App so that IPV6 is assigned to all devices at all times.

 

[anmolbhard004]

@vishalrao did you enable ipv6 on your Deco ?
Can you guide how do I do here in my deco
deco is getting internet on dynamic ip and yes the router [ Mikrotik in this case] is assigning ipv6 to lan.


Source


Source


Source

 

[vishalrao]

I cheated by putting my Deco units in AP mode and all wired and wifi clients get ipv6.

My tata play fiber Nokia 2524g something onu is in bridge mode and my TP-Link er605 router is where I configured ipv6.

But this was some time back... Currently not using ipv6 it's disabled most places.