QUOTE(vichitra @ Oct 12 2006, 07:48 PM) [snapback]65042[/snapback]
paste the output of dmesg and lsusb.
Are you sure eth0 instance of your USB interface is properly configured ?
/IMHO get one NIC card and use it./
[/b]
The relevant outputs are:
eth0 Link encap:Ethernet HWaddr 00:0F:A3:8E:2D:88
inet addr:192.168.1.3 Bcast:192.168.1.255
Mask:255.255.255.0
inet6 addr: fe80::20f:a3ff:fe8e:2d88/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:3 errors:312 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:126 (126.0 b)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:1874 errors:0 dropped:0 overruns:0 frame:0
TX packets:1874 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2584070 (2.4 MiB) TX bytes:2584070 (2.4 MiB)
---------------------
netstat -rn
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0 eth0
0.0.0.0 192.168.1.1 0.0.0.0 UG 0 0 0 eth0
---------------------
lsusb gives
Bus 001 Device 004: ID 05fe:2001 Chic Technology Corp.
Bus 001 Device 003: ID 1110:5c01 Analog Devices Canada, Ltd (Allied Telesyn)
Bus 001 Device 002: ID 058f:9254 Alcor Micro Corp. Hub
Bus 001 Device 001: ID 0000:0000
----------------------
lspci -vv -xx gives
00:00.0 Host bridge:
Intel Corp. 82810E DC-133 GMCH [Graphics Memory Controller Hub] (rev 03)
Subsystem: Intel Corp. 82810E DC-133 GMCH [Graphics Memory Controller Hub]
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort-