If you read it correctly....1.Go to WAN and add a new item,then Inspect Element the Type(where it says Routing) and change the value to “bridge”.Apply the settings and then refresh.If the type changes to “Bridge connection” you are good to go.Switch VLAN on and enter your VLAN ID as 100.
inspection element worked .. successfully changed to bridge mode and assigned /port binding to port 4 but after doing it mesh was showing no internet.. what did I do wrong?? [points to consider- turned on vlan assigned 100] did everything written up..Yes by default there is only routing, you need to manually enter the value bridge using inspect element. If you save in that state it changes to bridge.