Use Huawei E1750 in BSNL West

[Ankur Yadav]

hi,is this method working with K4505 in west region ie in MP ???T mobile software is not detecting my K4505...any solution ???

 

[Sahyadri]

Can some one tell me what si the driver version for Huawei Moobile Connect - 3G Modem.Mine is "2.0.3.827"

 

[kunalgautam]

Can some one tell me what si the driver version for Huawei Moobile Connect - 3G Modem.

Mine is "2.0.3.827"
I've the same

 

[ghpk]

Huawei posted some newer drivers on their forum, mine driver version is 2.0.6.702
this solved frequent disconnect problem which i was fed up of.

 

[chandansomani]

i too have 2.0.6.702 driver version but i m not able to connect using BSNL 3G...

 

[kapsa]

Driver Huawei 4.20.11.00


use this driver.it will remove error 619

---------- Post added at 12:17 PM ---------- Previous post was at 12:12 PM ----------

11.126.08.01.00.B418

if you have Huawei e1750 then update this firmware version.
it works in pune so i think will work in maharashtra.

 

---

[specially_foru]

Not working for me. Giving Error 635
Please help

Actually the problem can be understood by these two screen shots.



With Huawei E1750




With Huawei E1550

Both the screen shots were taken within a time difference of 5 minutes from the same pc and same placement of the modem.
Can anybody solve this?

 

[kunalgautam]

In linux, it can be connected via wvdial. I've used following config for wvdial config file. And it connects in just one dial 🙂



[Dialer Defaults]
Modem = /dev/ttyUSB0
Modem Type = Analog Modem
ISDN = 0
dns=4.2.2.2
dns=8.8.8.8
Baud = 115200
Username = user
Password = pass
Phone = *99#
Stupid Mode =1
Init1 = ATZ
Init2 = AT&F E1 V1 X1 &D2 &C1 S0=0
Init3 = AT+CGDCONT=1,"IP","bsnlnet".
Init4 = ATZ
Init5 = AT&F E1 V1 X1 &D2 &C1 S0=0
Init6 = AT+CGDCONT=1,"IP","bsnlnet".
Init7 = ATZ
Init8 = AT&F E1 V1 X1 &D2 &C1 S0=0
Init9 = AT+CGDCONT=1,"IP","bsnlnet".
Init10 = ATZ
Init11 = AT&F E1 V1 X1 &D2 &C1 S0=0
Init12 = AT+CGDCONT=1,"IP","bsnlnet".
Init13 = ATZ
Init14 = AT&F E1 V1 X1 &D2 &C1 S0=0
Init15 = AT+CGDCONT=1,"IP","bsnlnet".
Init16 = ATZ
Init17 = AT&F E1 V1 X1 &D2 &C1 S0=0
Init18 = AT+CGDCONT=1,"IP","bsnlnet".






Maybe that init string is not required for that many times.


P.S.: if you provide normal setting to wvdial iit still doesn't connect. And it would be helpful if some user confirms this.