Not getting speed more than 10Mbps

  • Thread starter Thread starter devesh3011
  • Start date Start date
  • Replies Replies 24
  • Views Views 6,437
devesh3011

devesh3011

Messages
12
Location
Anpara
ISP
BSNL
I recently got the BSNL Air Fibre connection and I have 50 Mbps speed plan but I am consistently getting 10Mbps speed. Not getting speed more than 10 Mbps. It's like it is somewhere capped at 10 Mbps.
I have checked ethernet cable and it is cat6 and it is fine.
 
Is it from the day you got it installed or you facing it after a few days ? Also mention Router you are using
 
Then the signal strength between your vendor's node and your node is not in the required bracket I guess. Do you have any metal objects or any trees in the line of sight of your CPE nodes ?

How high is the receiver installed from your roof ?
 
There can be a lot of reasons for this:

  1. What is your signal level and are the chains balanced?. If signal fluctuates in 80-89dbm range and chain imbalance is more than -5dBm you won't get speed.
  2. Which is your Wi-Fi router and what is the LAN speed FDX being shown in your CPE management page?. If it shows like 10mb/s FDX, you won't get more than 10mb/s. It should show either 100mb/s or 1Gb/s FDX.
  3. Is this a rural setup or urban?. Any other operators offering similar service?. Is there any noise interference?.
  4. Whether the LAN cable is properly crimped?. Can you share pictures of it on both ends?.
  5. Share pictures of your CPE and surrounding area.
 
Last edited:
shashankb said:
Then the signal strength between your vendor's node and your node is not in the required bracket I guess. Do you have any metal objects or any trees in the line of sight of your CPE nodes ?

How high is the receiver installed from your roof ?
Click to expand...
there is one tree but I am getting the very good signal strength so I don't think so the tree is problem here.
 
@Sai
I have no idea about EIRP limit but the LAN cable speed between CPE to my TP-Link router is 100 Mbps FDX
PFA the CPE pic

Source

there is one tree in near of CPE but getting the very good signal strength and i can see the tower from my eyes.
 
ONfrib2.png

xWfvEMT.png

You will get a status page showing data like this. Please share signal level screenshot from it.
 
Can you do something like a Speedtest between BSNL node and your Node . Is there a option like that in Mikroktik ? That way we can clearly know if its the Node limiting your connection or BSNL just screwed up your configuration which is not surprising if that happens
 

Similar threads

S
Full Speeds on Ethernet Vs Low Speed on Wifi
Replies
1
Views
680
unnecessary
itsmee
Low upload speed in Airtel Xtreme
Replies
7
Views
415
itsmee
S
Revo Fibre ONT slow WiFi speeds and Ethernet port is not working
Replies
0
Views
587
Sham412
M
How to bypass Jio ISP Speed limit on windows?
Replies
2
Views
491
mdp955
Top