How to put Syrotech SY-GPON-1110-WADONT in Bridge mode?

  • Thread starter Thread starter rajil.s
  • Start date Start date
  • Replies Replies 20
  • Views Views 10,368
Sort by date Sort by votes
its in bridge mode by default. you can connect ethernet cable ont to router and do pppoe on router.
 
Upvote 0
@rajil.s i guess its a single band wifi router. You are good as mac binding is for 2000 rs device. Just turn off wifi, use bridge mode, make sure u tick all ports while doing the change.
 
Upvote 0
The screenshot of the WAN settings is pasted below. The Add/Delete buttons are disabled. Also under dropdown 'Mode' the only option is 'Route'.

1605204467731.webp


How do i change settings to bridge mode?
 
Upvote 0
@rajil.s is the router is single band or dual band. How much u paid for security? Just change the mode to bridge instead of route and in binding options select all interface or lan 1 and lan 2 if it has two ports only.
 
Upvote 0
@rajil.s i had an gx and it had the option to change to bridge mode, though u can't delete or add profiles. But still that didn't work due to some mac binding even after changing mac in own router.
 
Upvote 0
@Aakash Malhotra This is temporary loaner from my LCO. My primary single port ONU (Syrotech) was not getting the full speed, so they have taken i back for firmware update.

Yes, can confirm that LAN2 is only 100mbit while LAN1 is gigabit.

I did the following steps:
1. Enabled the 'Delete' button using which i deleted the Internet profile
2. Enabled the 'Add' button using which i added a new profile
3. Before adding in the Step 2, i swapped Route and Bridge in the 'Mode'. For some reason the UI only shows the Route mode while the 'Bridge' is also in the html.
 
Upvote 0

Top