VOIP softphone setup with just ONT and nothing else.

  • Thread starter Thread starter sloj
  • Start date Start date
  • Replies Replies 63
  • Views Views 11,959

sloj

Disconnected
Messages
1,775
Location
Guwahati
ISP
BSNL

After this was posted, I looked again at my voice WAN config and realized its Service Mode was set to VOICE. So I changed it to VOICE_INTERNET and voila I can ping the voice gateway but not SIP server. So a static route needs to be made. Network -> Router -> Static Route and do the necessary changes.

Capture.JPG


Destination is the SIP server address, Gateway is voice gateway. And we are connected.

Things I did differently than the linked post. Disabled SIP under Application -> ALG configuration. Routers SIP ALG - VoIP-Info.

Updated Here
 
Last edited:
can you post your VOIP config once? am not able to ping both the voice gateway and the sip server
 
Upvote 0
Well, VOIP is registered now. LCO gave the wrong IP address in the settings. 🙂

EDIT: Voice gateway and SIP server are both pinging but UDP is showing down in Zoiper and GS Wave.
 
Last edited:
Upvote 0
Yup. It's different for everybody. Some may need it, some may not. Also just curious, where did it you ping it from, ONT diagnose tab or cmd prompt?
 
Upvote 0
Then you obviously need to static route it. I wrote about pinging it from cmd but I see it can confuse because I didn't write it explicitly. Also WAN config should be VOICE_INTERNET not just VOICE.
 
Upvote 0
The route doesn't do anything tho. Atleast it isn't supposed to.
There's already the 0.0.0.0 -> gateway default route.
 
Upvote 0
I tried almost everything I found in this forum. so much that my ONT hung up twice and I have to reset the do the config again. Not trying anything anymore, don't wanna break my precious ONT :-D 😛
 
Upvote 0

Top